I have my 4525-520 waiting for my kit. In the meantime I see that the 55mm 6mm shaft is required. However, on my motor now is a 50mm shaft (measured from the top of the can to the end of the shaft).
I have seen another build photo that shows a good bit of the shaft coming through the bearing and past the mount. Unfortunately, I don't know the motor or the shaft. I have asked the builder, but is unresponsive (so far).
Attached is a photo of the other builder's motor and mount so you can see what I'm questioning. Can someone give me the measurements indicated?
I have seen another build photo that shows a good bit of the shaft coming through the bearing and past the mount. Unfortunately, I don't know the motor or the shaft. I have asked the builder, but is unresponsive (so far).
Attached is a photo of the other builder's motor and mount so you can see what I'm questioning. Can someone give me the measurements indicated?