helinutz
27 September 2016 09:3427.09.2016 09:34
A question to those who have used the supplied tail blades - Did you add shims to the tail blades? mine seem reasonably loose in the holders, but not loose enough that I could get a washer in either side.
The blade roots are 4.95mm, the blade grips are 5.3mm, is that similar to others.
I don't want to distort the blade holders if I need to source some shims, however the gap seems too small to get a shim in both sides.
mahbouni
27 September 2016 23:0427.09.2016 23:04
Mine is the same. I just tightened them up a little bit so the blades have some resistance to me moving them.
My Logo 480 came with some black spacers for the main blades. I'm wondering if those could be used for the logo 700 tail but I can;t find them as a spare part on the Mikado website.
helinutz
28 September 2016 09:2528.09.2016 09:25
Looked at spacers, but they would need to be maximum of about 0.2mm each to have one either side.
Have just tightened them down for now but not 100% comfortable knowing I'm distorting the holders.
Would appreciate some input from Mikado as to whether this is acceptable or if I have some slightly faulty ones.
HeliALEX
28 September 2016 10:4428.09.2016 10:44
Hi guys,
we are flying the Helicopter since the beginning with the RotorTech 105mm blades so you don´t have to worry about that. Just tighten the Blade screws like on eyery other helicopter and it´s fine, that means it´s no problem to clamp the blade grips a little bit :-)
Greetings
Alex
Edited 1 time(s). Last edit at 09/28/2016 10:45AM by HeliALEX.