ChrisB
17 April 2017 09:3017.04.2017 09:30
I have two Logo 700s now and would like to build one as light as possible hopefully as light as a Thunder Tiger E700 i recently sold.
This need for a 55mm shaft is a bit of a pain,i noticed in the promo video Mirko stated' it can be the eli you need it to be' and that it can accept a wide range of power setups.
I want to run a pyro 700 and Jive Pro in one of them to reduce the weight.
Has anyone got one in theirs?
Ta
HeliALEX
17 April 2017 11:1617.04.2017 11:16
Hi Chris,
we´ve got a Logo 700 in the factory with a normal Scorpion 4525-520 Motor, a Jive 120A, for normal flight style the 120A is enough for sure ;-)
It´s als equiped with Savox 1257 and 1290, 4400mAh. Gens Ace 45C, NEO VBar and VTX 697 blades. Total weight is 4.93kg.
In my opinion with such a light setup, using a smaller motor which makes the heli lighter again should work if you can get a 6x55mm shaft somewhere. Using a counterbearing with this motor is a "must" in my opinion, because it has got an internal 6mm shaft, the Scorpion 4525 for example has got a 10mm which is way better.
Wolfram
17 April 2017 11:3017.04.2017 11:30
Hallo Chris,
with the Pyro 700 it is no problem to make your own shaft.
You´ll need 6 mm shaft steel and cut it to the length you need and of corse mount it to the bell.
The disadvantage of the 700 Pyro, the weak shaft, is now an advantage. It has no steps in diameter and no grooves for a secure ring.
Gruß, Wolfram
ChrisB
17 April 2017 17:2317.04.2017 17:23
Hi HeliAlex
Are you using the Helijive or Jive Pro 120?
From my experience,and from what i have read,the Jive Pro is much more sensitive to shutdowns due to current peaks than the Helijive was.
Wolfram
Thanks for the idea,i will look into doing this.
Thankyou both for your replies :-)
Wolfram
17 April 2017 23:5317.04.2017 23:53
Hallo Chris,
if you don´t need the higher voltage of the JIVE-Pro-BEC I would use the Heli-Jive, especially when you have it in your private storage.
Gruß, Wolfram
HeliALEX
18 April 2017 11:4118.04.2017 11:41
Hi Chris,
we´re using a Jive Pro 120A with a Scorpion HK-4525-520 and it´s working, but this heli is flown soft 3D ;-)
What size of batterys are you going to use?
I don´t know how high the current will be if you are using a Pyro 700 motor and which blades are you runnig?
ChrisB
19 April 2017 07:2519.04.2017 07:25
I will be using 4500mah packs and 697s