← Logo 700 and 800

Logo 700 tracking

Mikado Model Helicopters › Logo 700 and 800 · Started by Marianovbar on 29 February 2020 20:0729.02.2020 20:07
Marianovbar 29 February 2020 20:0729.02.2020 20:07
Hi, i have a logo 700 and recently repaired after a crash,i have a problem on the rotor when i flight the blades does not have tracking after 2 maneuvers the tracking begins and more if i give aileron or elevator inputs. Spindle, dumpers, blade grips, links, main blades and main shaft are new ones
Regards
Eddi E. aus G. 2 March 2020 08:4902.03.2020 08:49
Hi,

did you replace the yoke, or do you have a spare one to compare? Or maybe a 2nd 700 around with which you could swap rotor heads, to compare, to narrow it down?

Do I get it right, the blades run out of track if you start maneuvering, and don't track again if you come back into a stable situation, like ff or hovering?

Kind regards

Eddi

Born to fly ...
forced to work.
Marianovbar 2 March 2020 16:1702.03.2020 16:17
Hi, if i start to do 3d the tracking begins and when i come back to a hover has a lot of tracking but when i take off from 0 does not have it. I put a new rotor from my 2nd logo and the problem was gone, just change the yoke and main blade holder with the shims, bearings, dumpers and arms. I've been analyzed the rotor with the tracking problem and i found a little space between the fitting of the arm to the blade holder so i filed until fits right but i did not tested yet, if doesn't works i will try a completely new yoke.
Regards
Eddi E. aus G. 2 March 2020 16:3102.03.2020 16:31
Hi,

OK, please keep us updated, satisfy our curiosity :-)
With two similar rotor heads, there are options to track down the cause.

Cheers

Eddi

Born to fly ...
forced to work.
VStabi VStabi Pioneer of Flybarless