← Logo 700 and 800

MKS X8 servos in the Logo 700 translated

Mikado Model Helicopters › Logo 700 and 800 · Started by Speedy on 13 May 2017 00:1413.05.2017 00:14
Speedy 13 May 2017 00:1413.05.2017 00:14
Hi

I am currently building a Logo 700 with MKS X8 servos.
The instructions say I should use 17 mm for the servo horns.
Unfortunately, the servos are only available in 15 mm or 17.5 mm sizes.

Which measure would be more advantageous?
At 17.5 mm I'm worried that it's already too much.

Best regards, Maik
machine-translated from German · Show original
RV 13 May 2017 07:4913.05.2017 07:49
Ich würde die 17,5er nehmen und beim Setup eben den 8° sowie Pitchwert und Cyclic Ring anpassen.

regards (EN) / Gruss (DE)

Rainer Vetter

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Posting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.

Für Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollständig abarbeiten. Nehmt Euch Zeit, beantwortet Rückfragen in Ruhe und vollständig.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Für Einzelkommunikation bitte ausschließlich Email verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.
For single user communication please send a email only! PM, Messenger, Chat etc. won't be read.
Speedy 13 May 2017 12:4613.05.2017 12:46
Okay, thanks Rainer.

I'll do the same.

17.5mm at the rear as well?

Previously, the advice was always to attach the servo as close to the stern as possible.
This allows you to adjust the sensitivity.
machine-translated from German · Show original
HeliALEX 13 May 2017 13:0613.05.2017 13:06
Hi,

Yes, 17.5mm is also possible. With most servos, you can achieve over 100 points per side with 17mm, which results in good resolution.
If your readings are significantly below 100 for right/left, then you can attach the screws further inwards and adjust the stops accordingly.
machine-translated from German · Show original
Speedy 13 May 2017 14:3313.05.2017 14:33
OK thanks

Then I did everything right.


machine-translated from German · Show original
VStabi VStabi Pioneer of Flybarless