← Logo 400 ... 690

Logo 600 canopy

Mikado Model Helicopters › Logo 400 ... 690 · Started by beans07 on 3 October 2023 22:4103.10.2023 22:41
beans07 3 October 2023 22:4103.10.2023 22:41
Hello, I have a V1 Logo 600 that has been upgrade to a V1 600SX some years ago.

If I upgrade the frames to the V3 version will my V1 canopies still fit? or do I need to get some V3 canopy mounts to allow it to fit?
Eddi E. aus G. 4 October 2023 09:1204.10.2023 09:12
Hi,

technically, all canopies fit all chassis. V1 canopies will be a little tighter fit, though, so it can be necessary to adjust the mounts.
You can either buy a new set, or first try it on and see if it is enough to shorten the existing ones.

Kind regards

Eddi

Born to fly ...
forced to work.
beans07 4 October 2023 22:3304.10.2023 22:33
Thank you Eddi, I still have about 6 of the V1 canopies but want to upgrade to the newer V3 frames.
Eddi E. aus G. 5 October 2023 09:0405.10.2023 09:04
Hi,

the frames are actually V2. There were the original ones where the battery was slid in and secured with rubber rings in the very beginning, then with velcro straps. And then there's V2 which has the removable battery plate and quick release. This one's a tad taller, which 'stretches' the canopies somewhat differently, which in turn requires the standoffs to be somewhat shorter so it's not too tight a fit.
V3 again has a differently shaped canopy with a different color scheme, and that in turn also requires standoffs with slightly different length.
But everything can be arranged to fit :-)

—Eddi

Born to fly ...
forced to work.
VStabi VStabi Pioneer of Flybarless