← Logo 400 ... 690

diameter of 480 boom supports

Mikado Model Helicopters › Logo 400 ... 690 · Started by cudaboy_71 on 23 June 2025 04:4223.06.2025 04:42
cudaboy_71 23 June 2025 04:4223.06.2025 04:42
can anyone confirm the diameter of the boom supports on the logo 480? I picked up a used airframe and it has a terrible harmonic vibration at around 1900 (nothing before 1800 or after 2100) where the boom supports are vibrating like guitar strings. And, the vbar does not like it at all.

First thing I checked is the boom supports themselves. the manual (see attachment) says 5mm diameter. But, the ones on my kit are only 4mm. I think maybe a typo in the manual though, because the end links are proper mikado parts. But, I want to make sure before I order a new set. I'll be upset if i get the same thing that's already on it—4mm.

Eddi E. aus G. 23 June 2025 09:0223.06.2025 09:02
Hi,

it's a typo: the parts list says 4 x 2.5 x 387 mm.
You'd get the same.

But the harmonic/resonance is not caused by the boom supports, they are only animated.
Like the tail fin, at different frequencies, when it becomes blurry.

So even if you found 5 mm supports, and if they would not resonate at those frequencies, or not that much, the cause would still be there, and the effect on the gyros, too, if maybe a little less.

Did you check the vibration analysis already?
I'd suspect peaks at around 30-35 Hz (main rotor) or at 140-166 Hz tail rotor (or parts rotating at those speeds, respectively), and possibly even when testing without the boom supports installed (no risk unless you were to flip it violently).

Best,

Eddi

Born to fly ...
forced to work.
cudaboy_71 23 June 2025 22:4623.06.2025 22:46
thank you for confirming. i was about to order logo 550 boom supports. i guess that won't be necessary.

i have already started troubleshooting--rebuilt the head completely and re-lubed the main thrust bearings and checked the main shaft and feathering shaft, and checked all bearings.

checked the belt tension and that there are no extra twists.

tonight i can rebuild the tail and relube those thrust bearings.

vibration analysis didn't show any big spikes like i'm used to seeing. so, i'm just going through everything.
VStabi VStabi Pioneer of Flybarless