{"ok":true,"content":"RV wrote:<br> -------------------------------------------------------<br> That was the case there too. Regulations are in place. If<br> If you just &quot;measure&quot; now, you&#39;re measuring rubbish. Let it go.<br> &gt; simply staying in airplane mode, it&#39;s not there<br> &gt; Meaningful when stationary.<br> &gt;<br> Because - if you&#39;re going to do it, then you have to (especially if)<br> &gt; if the helicopter was on and\/or controlled for a longer period of time<br> &gt; has) Measure twice, offset by 180\u00b0, to account for cyclic components<br> &gt; to remove it. That&#39;s always been the case.<br> &gt;<br> &gt; But it still contains collective elements.<br> And with the current firmware, with ease<br> &gt; have there been more of them - however, even there are some<br> &gt; Even at ease = 0, collective components still exist<br> &gt; which become visible here depending on the situation.<br> &gt;<br> Therefore: That&#39;s exactly why there&#39;s been a version since V3.xx (!!)<br> &gt; Setup mode ....<br><br><br> So, I flew 3 batteries yesterday....<br> Rainer, something is definitely wrong. In the transmitter settings, the bar is at 0 when the pitch is in the center position (the small detent on the transmitter)!!<br> Then, in the trim menu, the folded blades aligned perfectly. Then I set the maximum pitch values, exited the menu, and didn&#39;t change anything else.<br> Once the target speed is reached, the helicopter takes off by itself!!<br><br> It&#39;s already clear that null pitch can&#39;t be right!!<br><br> No pitch curves are programmed into the transmitter except for autorotation.<br><br> No idea what&#39;s going on....<br><br> Regards, Florian<br><br> PS: Before the update, the bird ran perfectly.","note":"machine-translated from German"}