{"ok":true,"content":"Hello everyone,<br><br> I assembled a new model on the workbench, in which I wanted to use the VBar electric controller:<br><br> 6S battery (should be 12S in the model)<br> YGE 135 Opto controller<br> REX7 receiver<br> VBar Neo<br><br> Currently, I have the motor on a 3-position switch in the transmitter, with the motor OFF-idle-ON activated in the VBar.<br> Target speed 600rpm in VBar<br><br> The problem is that in VBar I constantly get the error &quot;No signal from speed sensor&quot; despite the flashing magnet LED.<br> and I have a &quot;faulty signal from the speed sensor&quot;.<br><br> I measured the speed sensor with an oscilloscope, and it cleanly switches the signal from 0-3.3V, is that correct?<br><br> I&#39;m not sure what else I should check\/adjust, any ideas?","note":"machine-translated from German"}