{"ok":true,"content":"Um... what? :-)<br><br> Quote: <strong>Chriss<\/strong><br> OK, does that mean that if the controller is set to ESC in the stabilizer, but the control is done externally?<br> Controller connected to ESC, stabilizer knows the motor-off position, stabilizer has the power<br><br> Quote: <strong>Chriss<\/strong><br> and if only gas in the foreign transmitter is set to external control<br> Contradictory: in that case you can&#39;t set any throttle values in the external transmitter, only consider the bank switch, which either switches throttle values (external control) or preset speeds (VBar Governor).<br><br> Quote: <strong>Chriss<\/strong><br> and in case of a malfunction, only the gas channel is programmed to be off.<br> That wouldn&#39;t make sense unless the throttle channel was responsible for bank switching. It would need to be checked if there&#39;s any doubt, but I think that once fail-safe is programmed, the receiver outputs previously stored positions from the transmitter, or holds if configured that way, and the VBar has to assume that what&#39;s being output is intentional and correct.<br><br> Quote: <strong>Chriss<\/strong><br> I can&#39;t see anything in the log at all in case of a malfunction\/fail-safe situation?<br> Yep. The VBar doesn&#39;t know where the signal comes from or under what conditions; as a somewhat flawed comparison, the signal could also come from a servo tester...<br><br> -&gt; No fail safe is stored in the receiver, hopefully it is not sending a signal (test), the VBar knows what it is, turns off hold\/motor and logs.<br><br> Otherwise... not.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}