{"ok":true,"content":"Unfortunately it took me a little longer, but I experimented a bit over the weekend.<br> Limiting the travel of the tail servo unfortunately doesn&#39;t help. However, I&#39;ve since discovered that my Logo has the same problem. When I apply pitch (it doesn&#39;t have to be full pitch), the tail moves to the right and then immediately back again.<br> But then I noticed that both helicopters also drift slightly to the left (tail to the right) while hovering. Not much, but about 10-15\u00b0C\/minute. I then replicated this at home with both helicopters without the blades. The sliding sleeve moves from the far left to the far right in about a minute. Is that possible? Vibrations are barely visible on the Logo (about 3 pixel rows from the bottom in 3 places) and on the Goblin, a maximum of 20% in altitude to the line (Vbar Control Vibration Monitor). The drift is the same for both helicopters and at the same RPM. Strangely, it only happens with the motor running; otherwise, I&#39;d be sure it&#39;s due to the Vbar Control... I&#39;m really at a loss and desperate now. Best regards, Markus","note":"machine-translated from German"}