{"ok":true,"content":"Hello<br><br> The NEO has been running well so far, but as part of general software maintenance I wanted to perform an update and now I have the following challenge:<br> - NEO had SW version 5.3?<br><br> - Connector bridge placed on the sensor<br> - Neo connected to 2s battery<br> - Vbar Control started<br> - USB cable connected<br><br> After that, the &quot;update&quot; ran two or three times and led to the following result.<br><br> VBar device found on path: E:\\<br> VBar device connected Serial number: 2001xx<br> Version: 0.0.0<br> Update: (Firmware Pl:56) update ...<br> VBar device connection disconnected<br><br> A connection to the setup software is no longer possible. Repeating the process yields the same result.<br><br> What options do I have to flash a firmware and get the Neo working again?<br><br> greeting<br> Andre","note":"machine-translated from German"}