{"ok":true,"content":"Good morning,<br><br> VBar NEO 1x1 :-)<br><br> If it works on the helicopter, it should first flash blue, then switch to green.<br> Then she would need to connect to the PC using the VBar configuration software (USB green = driver installed and active, Connected = connected).<br><br> When you plug in the BOOT connector (bridge plug, bind plug, loop) and then turn it on, it should blink white.<br> It will then register as a USB drive on the computer (like a USB stick) and connect to the VBar Control Manager.<br><br> If the NEO behaves this way but does not connect to the computer, there are several possibilities:<br><br> Is the USB port on the NEO defective or dirty (take a close look, in light, with a magnifying glass?)<br> USB cable defective (does another one work?)<br> Is the USB port on the PC defective or dirty (do other devices work on the same port\/PC?)<br> Windows USB subsystem &#39;broken&#39;, corrupted by an update, drivers corrupted (check in Device Manager?)<br> ...and many more :-) and countless others ^^<br><br> Cross-test: try connecting the stabilization unit to a different computer to see if it responds there?\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}