{"ok":true,"content":"Hi Kalle,<br><br> Congratulations on your new toy :-)<br> The transmitters are all normally delivered in Mode 2, but the conversion is simple.<br> We can also build the transmitter in Mode 1 upon request (it&#39;s assembled by us anyway), but I think a dealer like Friedel will also be able to modify it for you.<br><br> This is how you would connect it to the NEO if, for example, you were using direct current. In that case, you only need ground and a signal to control the module. No current flows in this configuration.<br> If cables\/connectors are damaged\/oxidized... then they should be replaced ;-)<br><br> I&#39;m not familiar with that helicopter, I don&#39;t know how the receiver power supply is implemented. But if it&#39;s powered by the ESC&#39;s BEC, it can certainly make sense to install capacitors to smooth out current spikes and back EMF. A BEC is simply limited; the advertised figures tend to be overly optimistic. This is in contrast to a fully charged battery. And since that helicopter has six digital swashplate servos... now think carefully before asking, but if I&#39;m not flying 3D... ;-) that has absolutely nothing to do with it. <a href=\"https:\/\/www.vstabi.info\/de\/node\/1315\" target=\"_blank\" rel=\"noopener noreferrer\">(Read up on it<\/a> .)<br><br> Sure, you should have been flying with analog servos ever since, &#39;because everyone says that&#39;s how it&#39;s always been and\/or is better&#39; ;-)<br><br> Excuse the little barbs I can&#39;t resist, but we&#39;ve been hearing the same thing for 10-15 years.<br> In my opinion, many manufacturers still haven&#39;t fully grasped that the world has continued to change in many ways.<br><br> In VBar Control, you can load\/save a model setup under Model Setup &gt; Model Tools. This saves the model setup to the transmitter, and if the cloud is active (Touch), it also uploads it to the network as a backup.<br> For special models where macrocells are programmed, you also need to go into the macrocell dialog, load\/save. Then... as before.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.<br>\n<br>\n<br>\n<br>\n1 mal bearbeitet. Zuletzt am 25.06.2021 10:01 von Eddi E. aus G..","note":"machine-translated from German"}