{"ok":true,"content":"Hi Eddi,<br><br> I just bought a Touch with case and transmitter tray from Modellbau Friedel and wrote &quot;Mode 1&quot; in the description. Let&#39;s see what happens.<br> It all kept bothering me, so now I&#39;m pursuing two paths simultaneously.<br> One more thing.<br> A switch for the multiplex light module was plugged into channel 8 of the Vbar Neon, and there was...<br> The negative, i.e., the black vein, is charred and covered with verdigris.<br> Red was tapped off and signal white and black minus were plugged onto the neon.<br> The module has a separate power supply of approximately 12 volts, which is taken from the battery via the balancer connector.<br> What could that be? A capacitor module is also installed for buffering; there are three capacitors on it.<br> a circuit board. Is that even necessary? I&#39;ve never used one in my entire life.<br> Oh yes, one more thing!<br> Can I back up everything that&#39;s on the Vbar Neon? So that if the module...<br> Something happens, and this can be replayed on a new Neon screen?<br><br> I know many questions.<br><br> I&#39;m looking forward to your answer.<br><br> Regards, Kalle","note":"machine-translated from German"}