{"ok":true,"content":"Hello Karl-Heinz,<br><br> This only really makes sense with VBar Control, actually only with touch.<br><br> Be careful with the PC software: if you change anything that affects the main rotor control loop, you&#39;ll overwrite all the custom programming. The PC software cannot read or adjust this level of complexity.<br><br> &#39;One could&#39; probably swap the AUX1\/AUX3 on the master stabilizer, but to do this one would have to reprogram it in the macro cells (using VBar Control), and know what one is doing.<br><br> I believe that if you convert the helicopter that RV painstakingly and lovingly converted to a 2x3 point setup back to a 2-point setup, it will jump for you with the n. H. i.&#39;s G. :-)<br><br> Now I&#39;m going to sit back and see what happens ^^\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.<br>\n<br>\n<br>\n<br>\n1 mal bearbeitet. Zuletzt am 21.06.2021 16:19 von Eddi E. aus G..","note":"machine-translated from German"}