{"ok":true,"content":"And that&#39;s precisely the problem; the drive is not suitable for this:<br><br> The drive is designed for:<br> 3.7V x 6 Z x 1800 KV x 11 Z \/121 Z =3632 1\/min<br><br> Therefore, anything below approximately 3000 rpm puts a lot of stress on the controller (partial load). 1800 rpm is far too low, which is why the speed control doesn&#39;t even reach the minimum throttle setting at the beginning...<br><br> Therefore, 3 possibilities...<br><br> - Motor with lower KV (approximately 1000 KV if designed for 2500 rpm).<br> - Use a 4s battery (designed for 2400 rpm)<br> - Use a minimum speed of 3000 rpm, 2500 can also be tested, but anything below that is not advisable.<br><br> The question of the rear axle ratio also arises. If it&#39;s traditionally around 1:4, as with Align, and not 4.5 or so... then low engine speed is also bad for the rear end.<br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i><br>\n<br>\n<br>\n<br>\n1 mal bearbeitet. Zuletzt am 25.07.2021 20:50 von RV.","note":"machine-translated from German"}