{"ok":true,"content":"Hello,<br><br> Since my Hobbywing ESC occasionally shuts down after several hundred flights, I got a used Jive Pro 120+ HV as a replacement and connected it just like the Hobbywing. Unfortunately, the ESC isn&#39;t initializing, and I have no idea why.<br><br> If I connect the ESC directly to the REX 3 (Jeti), it initializes and boots up without any problems. However, if I assign the same channel to AUX3 in the VBar software and change nothing else, it doesn&#39;t initialize or boot up, except for the BEC, which works perfectly. Since the VBar simply passes the channel through, this behavior is baffling. The latest software version is installed on the ESC.<br><br> If the paths were incorrectly programmed, it wouldn&#39;t even start up directly from the Rex receiver. I hope someone can help me with this; my search didn&#39;t turn up anything useful. Of course, I could connect the ESC directly to the receiver, but I don&#39;t want to. Firstly, it worked well with the Hobbywing ESC for several years, and secondly, I want the power supply as close as possible to the components.<br><br> Best regards<br> Dieter<br><br><br><br> Edited twice. Last edited on 01.08.2021 at 10:58 by dit71.","note":"machine-translated from German"}