{"ok":true,"content":"Good morning,<br><br> The motor switch (OFF-IDLE-ON(Bank)) is located upstream of the bank switch (70-80-90).<br><br> In the configuration of external controllers, no controller control loop is active; only a gas value is output.<br> If the model were _not_ powered (engine OFF or IDLE), the control loop would be slightly mitigated or adjusted so that the model goes through the AR better and is not so likely to tip over even on a &#39;crooked&#39; AR.<br> Additionally, log entries are written when the motor and bank switches are operated, which can be helpful in troubleshooting.<br><br> The rotational speed needs to be measured. This can be done externally, or if the controller outputs a speed signal, or if a sensor is used, the speed can also be read in the software (calculation in the Gov. II tab if the VBar Governor is enabled).<br> Of course, you can also use existing telemetry from your own remote control system for display on the transmitter, if available and compatible.<br> That bypasses the stability control system.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}