{"ok":true,"content":"Hi,<br><br> Quote: <strong>Chriss<\/strong><br> Why do I actually need &quot;idle minimum speed&quot;?<br><br> Why isn&#39;t &quot;Off&quot; and &quot;On&quot; speed enough? And couldn&#39;t &quot;Off&quot; also include AR (Automatic Reaction Alert)?<br><br> Imagine you&#39;re practicing autorotations. Oops, not enough, too low, too fast, blade stop \u2013 so, switch it on, o-oo-oooh soft start (internal combustion engine: engine off, doo-doo), alternative landing (fee applies).<br><br> With AR idle, the motor idles smoothly, both electric and combustion engines, and when you switch back to ON, sssst, in about two seconds you have revs again, and can practically immediately control, catch, and climb.<br><br> Of course, if you fly autorotations like a man :-), then OFF and ON is sufficient.<br><br> Quote: <strong>Chriss<\/strong><br> &quot;It would be possible to connect the controller or throttle servo to AUX3, and to enter the original throttle channel (or a channel with a slider...) at AUX3.&quot;<br> Then the VBar&#39;s throttle logic is completely bypassed; you can switch and control (or push) the transmitter as before.&quot;<br><br><br> This is how I solved it... does the Neo then register the different rotational speeds, or is it not important for the control circuit?<br><br> She won&#39;t get it.<br><br> Quote: <strong>Eddi E. from P. formerly from G.<\/strong><br> In that case, it would still be useful to operate the motor switch status so that the VBar &#39;knows&#39; when the model is driven and when it is not.<br><br> Quote: <strong>Chriss<\/strong><br> Why don&#39;t I see the 80\/90 in my setup?<br><br> Because you haven&#39;t set them? Bank 1 (active, on the right in the picture) is set to 70.<br> Switch to bank 2, place the cursor in the field, delete the 70, enter the 80, press (Enter).<br> Switch between 1 and 2, and it will switch between 70 and 80.<br> Homework: set bank 3 to 90 :-)<br><br> The throttle value for autorotation (idle) is always shown below.<br><br> But note: these are throttle values (servo positions) that are output at the ESC connector.<br><br> If you are connected to AUX3,<br><br> Quote: <strong>me again<\/strong><br> The VBar&#39;s gas logic is completely bypassed.<br><br> Freely adapted from Jack Sparrow: clear so far?! :-) \r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}