{"ok":true,"content":"Hi Chriss,<br><br> Forget everything that was before.<br><br> In my humble opinion, there was never a speed switch on the transmitter; that&#39;s just pilot fantasy.<br> Just like sliding panels, simply because you once looked into a cockpit and saw that they have something like that between the seats and slide it around. I want that too!! And lots of switches!! Yay!!<br><br> :-)<br><br> No offense intended, right?<br><br> Third-party transmitters also had an AR switch (4th flight phase, with or without idle, own flight parameters (pitch\/dual rate\/expo\/sensitivity etc.)) and a flight phase switch (1st-3rd flight phase with 3-way switches, for three times own parameters, each flight phase also included a so-called throttle curve).<br><br> No speed control.<br><br> \/\/wipe&amp;gone<br><br> 1. Three-way switch, OFF-IDLE ((AR ;-)), ON<br> 2. Three-way switch, Bank1\/2\/3, 3 x different flight parameters including the RPM setting or the throttle value for it.<br><br> Now it gets more complicated or complex again, because your transmitter has a complete helicopter program, which nobody needs (anymore) since flybarless.<br> The difficult thing is to think simply:<br><br> Normally, every transmitter with 6\/7 channels or more has two additional channels, named Gear\/Landing Gear and Gyro Gain\/Sensitivity, which are also switched in conjunction with flight phases. Or AUX1\/2, or something else.<br> Program one channel switchable with a flight phase switch to bank, and one with a discrete switch to motor, and you&#39;re done.<br><br> Ta-da! :-) \r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}