{"ok":true,"content":"Good morning,<br><br> He said &quot;Schieber,&quot; stone him :-) ... but only because it&#39;s roughly from the same period :-) Stone Age :-)<br><br> It would be useful to use the VBar&#39;s throttle logic. OFF\/IDLE\/ON (separate channel, 3-way switch) and Bank 1\/2\/3 with three RPM presets (separate channel, 3-way switch).<br> This means there are five states: OFF-OFF, IDLE-Minimum speed, ON-Speed from the selected bank.<br><br> Disadvantage: the rotational speeds are stored in the VBar and can only be changed using a computer (or from the transmitter with VBar Control).<br> Advantage: You can switch the remote control system without having to make any settings... only the channel assignment needs to be re-established. Everything is stored in the VBar, in the model. Plus, VBar performs a failsafe if it detects it.<br><br> It would be possible to connect the controller or throttle servo to AUX3 and enter the original throttle channel (or a channel with a slider...) at AUX3.<br> Then the VBar&#39;s throttle logic is completely bypassed; you can switch and control (or push) the transmitter as before.<br><br> It would also be possible, if you have a full-fledged receiver with servo connections, to connect the controller or the throttle servo there.<br><br> In that case, it would still be useful to operate the motor switch status so that the VBar &#39;knows&#39; when the model is driven and when it is not.<br> One must also deal with fail-safe systems and, if necessary, even switch off the engine oneself.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.<br>\n<br>\n<br>\n<br>\n1 mal bearbeitet. Zuletzt am 03.08.2021 09:50 von Eddi E. aus G..","note":"machine-translated from German"}