{"ok":true,"content":"Hi Chriss,<br><br> &#39;That depends&#39;.<br><br> Good operating conditions prevail with low vibration levels.<br> The alignment should be parallel to the axes to be stabilized (roll-pitch-tail).<br> The stabilizer should not be able to move independently of the model.<br> It should be located as far away as possible from interfering fields (electrical\/magnetic) and random electrical disturbances (electrostatic discharges).<br> VLink (antennas) should allow them to be positioned so that they are as far apart as possible and can be freely positioned in different directions.<br><br> However, this applies in principle to every electronic device on the model, or (VLink) to every receiver on the model.<br><br> For conventional designs (trainers with the motor\/controller in front of the main rotor shaft, or internal combustion engines), mounting the motor behind the main rotor shaft, on the chassis, has proven effective. For scale models, it&#39;s often preferred to mount it away from the mechanics, within the frame.<br> The crucial point (in the truest sense of the word) can now be the short distance to a tail belt, especially VLink (generally: sensitive transistor circuits in the radio receiver) are very sensitive to electrostatic discharges (even to the point of destroying components), with pure flybarless (or earlier, tail gyro) this is (was) less critical.<br> The problem can be remedied by installing an anti-static kit, essentially a potential equalization between the two ends of the belt (Van generator), or between the rear housing\/pressure roller (something electrically conductive that touches the belt at the rear) and the chassis (ideally something electrically conductive that touches the belt at the front, e.g., belt calmer\/tensioner).<br><br> Now it&#39;s your turn: what kind of helicopter, what possibilities did the designer provide or &#39;leave open&#39;?\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}