{"ok":true,"content":"Hi,<br><br> So, the thing with the three shells \u2013 uh, four seconds :-)<br><br> The process is essentially as follows:<br> Rescue Start<br> The helicopter rotates into its normal position (relative to the <i>artificial<\/i> horizon) and simultaneously steers away from the ground.<br> ...rescue ends when normal position is reached, helicopter climbs a little further, pitch reconnects to the stick position from the transmitter.<br><br> If this state cannot be reached within four seconds, the rescue will be automatically terminated.<br> You can simply try it on the floor:<br><br> The helicopter is upright, the rescue start and end come almost simultaneously, pitch up, and you bring it back down with the stick.<br> Helicopter is on its side, rescue start, swashplate controls, you right the helicopter when it is somewhat upright, rescue end, as before.<br> The helicopter is on its side, rescue operation begins, the swashplate is controlling it, you just wait, after about four seconds the rescue operation ends, and you regain normal control.<br><br> You can override the controls significantly, for example by more than 50% deflection; then the log will also record that the rescue system was overridden by the pilot.<br> We&#39;re being cheeky and want to know if he had his fingers in it :-)<br><br> The horizontal position is virtual. Simplified, like in an airplane at night and in fog. The accelerometers act as a kind of &quot;seat-of-the-pants&quot; feel, but depending on the flight conditions or vibrations, this can also be misleading.<br> Even if the artificial horizon tilts, is crooked, or upside down, the trained pilot will rely on it 100% and steer the aircraft as he sees fit, for better or for worse.<br><br> The stability control can&#39;t do anything differently. Then the pilot resists, and... four seconds.<br><br> The rescue will work if the platform\/carrier\/helicopter is functioning; there&#39;s no getting around that.<br><br> With the TDR\/F\/SF, one could try mounting the NEO with the servo cables facing backwards, so that the rear third, where the sensors are, no longer springs on the springboard, but rests on the diving tower (mounting).<br><br> With the Rex, you should at least move the NEO away from the front of the bike to a secure surface that doesn&#39;t wobble\/swing\/is in close proximity to the drive electronics and mechanics.<br><br> So far, so good.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.<br>\n<br>\n<br>\n<br>\n2 mal bearbeitet. Zuletzt am 01.04.2021 10:56 von Eddi E. aus G..","note":"machine-translated from German"}