{"ok":true,"content":"Hello Dieter,<br><br> Firstly, the sensors are recalibrated when switched off\/on, or accumulated values in the mathematical model are reset to zero.<br><br> On the other hand, the whole thing naturally neutralizes itself almost automatically over time, if the sensors (in this case at rest, on the ground) can record the acceleration due to gravity undisturbed for a sufficient amount of time.<br> This can also be clearly seen in the rescue status display, where the dot slowly moves back to the center.<br><br> This also works in flight, but only if the load is not constantly excessive, as a constantly high, unfavorable vibration level has a negative impact.<br><br> Therefore, the rescue function works as intended after being switched on, but over the course of a flight \u2013 more or less quickly \u2013 it may no longer function properly.<br><br> Quote: <strong>dit71<\/strong><br> Why is it that when the rescue system works well, I can override the helicopter and take control again within a very short time, but when the rescue system goes awry, it feels like it takes significantly longer to regain control?<br><br> Quote: <strong>I, above<\/strong><br> For us, the perceived eternity ends after a maximum of 4 seconds (timeout if normal flight attitude cannot be reached), ...<br><br> If you overcompensate, you essentially prevent the assumed normal flight attitude from being reached again, and only delay the situation until the timeout kicks in.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}