{"ok":true,"content":"Thank you so much for the helpful tips!<br><br> Of course, not all the parts are original anymore; various bearings and shafts have been replaced at some point, but not all at once. The last change to the T-Rex this past weekend was replacing the engine mounts and shaft, but that shouldn&#39;t cause any problems. It&#39;s been two years since I replaced the DFC cylinder head with a conventional one, but I wouldn&#39;t know where else to mount the stabilizer bar on the T-Rex without major chassis modifications.<br><br> I replaced the &quot;pirate plank&quot; on the TDF with a continuous square tube right from the start, as the Spirit&#39;s rescue function simply didn&#39;t work with the TDF at all. It even had a built-in vibration analyzer! The weeks-long odyssey back then involved analysis without blades, then without the tail belt, then without the freewheel, then sending the engine first to Kontronik, then to Jan \u2013 ultimately, none of it helped, hence the switch to the VBar. The advantage of the Spirit in this respect is that as soon as you release the rescue brake, you have full control again; with the VBar, even in oversteer, it feels like an eternity before you regain full control.<br><br> I wouldn&#39;t even know where to begin. The blades are balanced both statically and dynamically with tape, and the blade tracking is fine. Sure, I could replace all the bearings and shafts and spend the next few weeks troubleshooting, but if I don&#39;t get any more concrete suggestions, I&#39;ll leave it as is and move the problematic maneuvers to the end of the flight. If it&#39;s just the piroflips, I can live with that.<br><br> In this context, I find your video about the Wag Sup interesting. Didn&#39;t you repeatedly emphasize the importance of checking the smoothness of the mechanics when dealing with &quot;tail problems&quot;? Then, suddenly, the video mentions that the imprecise positioning of the fast servos is to blame for the oscillation. I have to admit, my ears perked up at first ;-)<br><br> Best regards<br> Dieter","note":"machine-translated from German"}