{"ok":true,"content":"Hello,<br><br> Over the weekend, I updated the Neo VBar systems in my T-Rex 700 and TDF to the new Pro Rescue version. A Jeti transmitter is used, and a Rex 3 receiver is doing its job.<br> I have temporarily set Lightning and Wag to 0 on all banks, leaving everything else as it has been set for hundreds of flights.<br><br> Both helicopters exhibited the exact same behavior today:<br><br> After takeoff and hovering in normal or inverted flight, the reserve parachute works perfectly as usual; even rolls or tic-tocs don&#39;t disrupt it. However, as soon as I perform a few piroflips and then activate the reserve, one can only hope that the VBar will quickly return control to the pilot before the helicopter hits the ground. The first time this happened, due to the element of surprise, it was a very close call, almost resulting in a crash. During the three flights with each of the two helicopters, I was able to reproduce this issue multiple times and at any point. (Once it was a very close call until I was finally able to override the reserve.) The more consecutive piroflips I performed, the more pronounced the malfunction of the reserve became, ranging from a slight upward tilt to a very concerning downward drift.<br><br> Since the rescue function is more important to me than the anti-gravity function, I absolutely want to reload the &quot;old&quot; software onto the VBar, but I don&#39;t know how to do that?<br><br> I understand that neither the T-Rex nor the TDF are exactly vibration-free, but I couldn&#39;t reproduce this behavior with the old software, and I tried it many times because I want to be sure that the rescue system will work if I ever need it and that I can rely on it!<br><br> Best regards<br> Dieter","note":"machine-translated from German"}