{"ok":true,"content":"Hello,<br><br> I used the pre-configured setup on the NEO no Vlink for my 600-SE.<br> When I checked everything again, I noticed that I couldn&#39;t adjust the sensor alignment in the finished setup; I could only adjust the correct position via the sensor alignment after the setup.<br> Now, when I edit the setup, the sensor orientation (O\/V) is different from the general settings under Sensor Orientation O\/H. How do I make both settings show the same orientation?<br><br> greeting<br><br> Ronald<br><br> VBar Control<br> EC145 Neo<br> Logo 600SE Neo<br> T-Rex 600 N Vstabi<br> Logo 600 Neo<br> Logo 700XX Neo<br> Stuka JU 87 Vstabi file attachments:<br> <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?53,file=26131,filename=Allgemein-Sensorausrichtung_LOGO_600_SE.bmp\" target=\"_blank\" rel=\"noopener noreferrer\">Open<\/a> | <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?53,file=26131,filename=Allgemein-Sensorausrichtung_LOGO_600_SE.bmp,download=1\" target=\"_blank\" rel=\"noopener noreferrer\">Download<\/a> - General-Sensor Alignment_LOGO_600_SE.bmp (2.1 KB)<br> <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?53,file=26132,filename=Setup_LOGO_600_SE.bmp\" target=\"_blank\" rel=\"noopener noreferrer\">Open<\/a> | <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?53,file=26132,filename=Setup_LOGO_600_SE.bmp,download=1\" target=\"_blank\" rel=\"noopener noreferrer\">Download<\/a> - Setup_LOGO_600_SE.bmp (2.1 KB)<br>\n                    \n                ","note":"machine-translated from German"}