{"ok":true,"content":"We have addressed precisely this unnecessary level of complexity \u2013 &quot;setting up a channel-thinking transmitter&quot; \u2013 which many pilots would actually have to solve using the transmitter manufacturer&#39;s instructions\/support and which they struggle with, by launching a VBar Control\/VBar Control touch.<br><br> We also took care of the learning process - Scorpion and YGE controllers automatically recognize this on the NEO with VBC\/VBCt and can also be programmed via VBC\/VBCt.<br><br> Generally, you simply need one &quot;channel&quot; for the motor (Off-AR-ON), one for each bank (1-2-3), and then you set the percentage of the controller&#39;s output for each active bank in the PC. The RPM is then banked. For pitch control calibration, the direct throttle mode in the governor panel must be activated and left on until complete, even beyond the power cycle (some older controllers require full throttle for calibration).<br><br> The kill switch \u2013 if desired \u2013 must be provided by your transmitter by setting the motor channel to off when the kill switch is activated.<br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i><br>\n<br>\n<br>\n<br>\n1 mal bearbeitet. Zuletzt am 27.09.2021 18:31 von RV.","note":"machine-translated from German"}