{"ok":true,"content":"Hi Rainer,<br> Thanks for the reply.<br> I&#39;m trying to figure out how to switch banks, but there are quite a few things I don&#39;t understand.<br><br> The GOV -100 \/ 0 \/ 100 is now connected to the 3-phase switch (Rudd D\/R). What is being switched now? Engine speed?<br><br> So the gyro is now also assigned to the gear switch -100\/100. What does this switch? Tail sensitivity?<br><br> Then there&#39;s the F mode switch which controls the throttle, also with 3 phases: 0\/50\/100 throttle.<br><br> Where do I adjust the throttle curve?! Simply in the throttle curve settings on the transmitter?<br> Is there no kill switch anymore?<br><br> Things used to be somehow easier<br> Dx7se<br> Black Mini Vstabi<br><br> Perhaps I should consider the Aux option. When I connect the cable from the controller to the Aux3 channel, the motor beeps continuously, indicating that the throttle isn&#39;t fully depressed.<br><br> Please excuse my silly questions, it&#39;s been at least 10 years since my last 3D helicopter flight.","note":"machine-translated from German"}