{"ok":true,"content":"Good morning,<br> I have a Logo 480 with a Vstabi Neo and an HW 100A ESC. I&#39;m using a Spektrum DX8 transmitter. The stabilizer is equipped with two satellites (DSMX).<br><br> I would like to use the gov function of the hardware controller. However, it only works partially.<br> There are 3 cables coming from the controller; if you use the hwgov, you simply leave the RPM connector disconnected, right?<br><br> I&#39;ve gone through all the tabs in the setup and everything works so far.<br> The last two controls are irrelevant to me since I&#39;m using an external controller.<br> However, the Vstabi doesn&#39;t seem to be passing the throttle signal through correctly.<br> A gas diagonal is set from bottom left to top right.<br> I also can&#39;t access the throttle path programming. When I connect it at full throttle, it only beeps to tell me that I&#39;ve connected a 6S battery.<br><br> Perhaps someone can help me? Maybe an explanation of the wiring?","note":"machine-translated from German"}