{"ok":true,"content":"Hi,<br><br> Generally speaking, with two satellites, there is redundancy. Both connections are monitored, the same control signals are received (redundantly) on both, one input is used at a time, and if there are problems, the system switches seamlessly and without notification to the other.<br><br> If nothing more comes in there, the other input is switched back on.<br><br> If nothing is received on that satellite either, an input packet has been lost, and the system switches back to the other satellite to see if it&#39;s now delivering anything. If only one satellite is used, or if nothing is received on either (cause: unclear; we only know that we&#39;re not receiving any input packets with control information)... Fail Safe means motor off, servos on hold.<br><br> As soon as signals are received again, control can be restored, and the engine would also restart (electric, soft start, combustion engine possibly even if it was still running at idle).<br><br> The cause definitely lies &#39;outside the socket&#39;, cable, plug, satellite; then it could be an electrical problem (receiver brownout, which is rather unlikely now or without other messages like undervoltage, warm start) or a radio problem, e.g. blockage\/shadowing, range; in the worst case, the frequency spectrum is also so congested (radio masts nearby, for example)... you just don&#39;t know.<br> Even if the transmitter stops broadcasting or is switched off...<br><br> You can play through the scenarios on the ground, simply unplug satellites or switch off the transmitter while the system is running, and see what the log shows \u2013 that&#39;s how it happens in flight too.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}