{"ok":true,"content":"The problem is now solved:<br><br> Binding without the VBAR NEO software worked perfectly (using the satellite&#39;s push button). I can&#39;t say why the same binding sequence didn&#39;t work when integrated into the running VBAR software; I unfortunately overlooked that possibility, sorry. I was too focused on the stabilization setup. (I should also mention that I didn&#39;t try the push-button method that was necessary very often, and that pressing the button to connect and using the mouse simultaneously wasn&#39;t so easy. But I think it simply wasn&#39;t possible with the software running.)<br><br> I have now bound two satellites without using the receiver setting in the VBAR software. I adjusted the settings there afterwards.<br><br> But now, due to the motor cutoff issue, I have another important question: What&#39;s the best way to implement telemetry transmission (Va ESC telemetry) with my Hobbywing 80A V4 + Spektrum satellite receiver + VBAR NEO + Spektrum NX8 setup? I&#39;ll try to do some research, but so far I&#39;ve only found information on VBAR control, and some sources claim it&#39;s not possible with Spektrum at all. It might be important to know this in case something like this happens again.<br><br> What do you experts say: Could the stabilizer be involved in a sudden engine shutdown after more than 30 minutes of decent flight? I&#39;d guess probably not.<br><br><br><br> Edited 4 times. Last edited on 14.10.2021 at 19:50 by alugaga.","note":"machine-translated from German"}