{"ok":true,"content":"Hi,<br><br> um, no :-)<br><br> It works as described in the software: 1-2-3.<br><br> 1. This corresponds to creating a model memory with H-1, without a mixer.<br> 2. Connect to the VBar, no receiver required<br> 3. Click, briefly disconnect power, quickly link the satellites, start the binding procedure on the transmitter.<br><br> Anything else would be nonsense and far too complicated, wouldn&#39;t it? Including having to look it up somewhere you wouldn&#39;t even think to look.<br><br> My example was simply, in response to your comment, that once a satellite is bound, it &#39;in principle&#39; works with any stabilizer.<br> Regardless of whether it is attached to the stabilizer, or even if it was previously attached to a receiver.<br> The radio communication (the binding) happens on the spectrum side, and only the control signals (or, in our case, a trigger signal to the satellite) come through the cable.<br><br> Greetings<br><br> Eddie<br><br> Born to fly ...<br> forced to work.<br><br>","note":"machine-translated from German"}