{"ok":true,"content":"Thanks for the info. I&#39;ve made some progress (almost finished, I hope). But I&#39;m getting stuck on the ESC programming. I haven&#39;t flown in 10 years, and a lot has changed.<br><br> So, here&#39;s what I did.<br><br> All settings were copied from references and the helicopter parameters were adjusted up to the last two setup points, controller 1 and controller 2.<br><br> I&#39;m using the Hobbywing Platinum 80A speed controller. It&#39;s largely pre-programmed at the factory (via the LCD programming box: Elf Governor, 7.4V Bec, etc.).<br><br> In the controller set 1, I have selected: VBar electric controller. The ESC is connected to ESC (the BEC is on AUX2).<br><br> In controller set 2, I entered 5.7 for the gear ratio (according to the Goblin Buddy manual, the reduction ratio between the pinion and main rotor is specified as 5.7:1). For sensor configuration, I entered half the number of motor poles (5). \/\/\/ I don&#39;t really understand everything above and to the right of that (I also don&#39;t really know what an external governor is, but as far as I can tell, this setup with VBar control is standard).<br><br> If I leave the setup as is and select &quot;Motor on,&quot; the motor spins at a presumably low speed that increases depending on the pitch input (+ and -). However, switching banks has no effect except that the default value changes.<br><br> What would be the next steps now? Or rather, here are my questions again:<br><br> 1. Do I need these throttle servo settings for my electric helicopter? No, right? If the ESC was programmed normally using the Hobbywing programming box, is that sufficient? The only throttle curves I need to program on the transmitter are the bank curves with 0, 50, and 100% linear settings for each bank coordinate system, correct?<br> - 2. I inserted the RPM signal cable, which only has one wire with a contact, into the RPM slot so that the single contact is on the negative terminal. Is that correct? It hasn&#39;t changed anything about the situation described above. What is an RPM pulse?<br> - 3. What is meant by slave?<br> - 4. Why doesn&#39;t switching banks work in my setup, but turning the engine off and on does?<br> Thank you so much for your help!<br><br><br><br> Edited 3 times. Last edited on 10\/10\/2021 at 20:16 by alugaga.","note":"machine-translated from German"}