{"ok":true,"content":"I would appreciate help clarifying some points regarding the VBAR NEO.<br><br> 1. I was told the following about the relevance of the servo parameters center pulse and control frequency:<br><br> - The center pulse must be correctly set (in my case via Vbar Neo), otherwise the servo will break.<br> - The control frequency should be approximately 200 - 333 Hz and must not exceed the maximum value of the servo.<br><br> Since these values are supposedly so important, I actually expected them to be among the first things you can configure in the vBar software. But so far, I haven&#39;t been able to figure out which setting is currently active or where I can adjust it.<br><br> 2. The instructions say to set the swashplate settings on the transmitter to an H1 configuration. I couldn&#39;t find that designation anywhere on my NX8. I chose the &quot;Normal&quot; setting instead, since all the other settings involve 2-4 servos. Is that correct?<br><br> 3. Does anyone know the exact binding sequence for Spektrum satellites + VBAR NEO + NX8? I had to fiddle around for over an hour before I finally got it to bind with an old, used satellite. I have no idea what I did differently. I only had two satellites plugged in, possibly even different ones, and the old one (which doesn&#39;t even have a push button) connected by itself.<br><br> I would be grateful for any help.<br><br><br><br> Edited once. Last edited on 09\/10\/2021 at 18:50 by alugaga.","note":"machine-translated from German"}