{"ok":true,"content":"Hello,<br><br> I already got the following message in my new 700 (Specter V2) after the third setup flight:<br><br> 10\/28\/2021 4:45:53 p.m. Info;Increased vibration level<br> 28.10.2021 16:45:54 Warning; IMU Sensor Z axis is stuck<br> 28.10.2021 16:46:03 Info; Bank 3 loaded<br> 28.10.2021 16:46:03 Warning; Strong vibration<br> 28.10.2021 16:46:05 Info; IMU sensor Z axis has come loose.<br><br> This now happens on every flight. I then switched to the standard initialization mode:<br><br> Oct 29, 2021 3:28:14 p.m.;VBar Start -- SpecterV2<br> 29.10.2021 15:28:14 Good; Reset Reason: Power On<br> 29.10.2021 15:28:16 Info; Bank 3 loaded<br> 29.10.2021 15:28:16 Info; Bank 4 loaded<br> 29.10.2021 15:28:16 Warning; IMU Sensor Z axis stuck<br> 29.10.2021 15:28:16 Good; Motor switch Motor Off<br> 29.10.2021 15:28:16 Good; Engine switch Idle Start<br> 29.10.2021 15:28:17 Info; Calibration completed<br> 29.10.2021 15:28:17 Info; Initializing with virtual Z axis<br><br> Am I seeing this correctly? A warning will still be issued regarding the virtual Z-axis.<br> At home on the table, I can release the sensor by tapping it on the stabilizer.<br> Should I just continue flying in standard mode? Precision mode isn&#39;t working anyway.<br> The helicopter would be anything but saved there. During a ground test, the<br> The swashplate made a brutal rightward swing after I activated the rescue function.<br><br> It&#39;s a brand new Neo with an aluminum case.<br><br><br> Regards, Reini","note":"machine-translated from German"}