{"ok":true,"content":"Hello G\u00fcnter,<br><br> I always do it that way to get the BEST resolution.<br><br> - Setting the total pitch range, e.g. -4 (please leave some reserve, -2 is too little for AR with profiled blades) to +12 = total 16 degrees.<br> - In the Trim tab, reset everything to zero, place the servo lever on the RW position, and if necessary, trim again until RW is reached - remain in Trim mode (servos are locked).<br> - Lengthen the linkage to the TS so that TS RW and center of the shift path<br> - Lengthen the rod to the head so that half the pitch range (-4 + ((abs(-4)+12)\/2) = +4 degrees) is now applied.<br> - Finish trim<br> - Measure the pitch, first setting it to +-100.<br> - If necessary, choose a different servo arm if the pitch min\/max of -4 \/ +12 is not reached or is much too high, then the desired value may need to be changed.<br> - Set pitch min\/max<br> - Open the Trim tab, measure the pitch, leave the gauge in place (blade over the tail boom)<br> - Exit trim, call up and set 8\u00b0 (there should now be an 8\u00b0 difference at the tail boom blade, direction doesn&#39;t matter)<br> - If 8\u00b0 is not reached - possibly the cyclic ring is too tight (85 is normal to start with) or the servo arm is now too short.<br> - With large scalers, feel free to score 10-15 points more.<br> -8\u00b0 end<br> - TS with pitch lever at 0\u00b0<br> - Scroll down in TS Expert, set zero pitch<br> - If necessary, make the cyclic ring slightly narrower (approx. 65) if it is now in the floating range.<br> - You might need to adjust the pitch curves in flight; that&#39;s a matter of personal preference and completely up to you ;-) - I like to have 0\u00b0 centered on all my helicopters and cheat a bit to adjust it. For a scaler that doesn&#39;t like that, it should be roughly correct.<br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i><br>\n<br>\n<br>\n<br>\n1 mal bearbeitet. Zuletzt am 27.11.2021 14:04 von RV.","note":"machine-translated from German"}