{"ok":true,"content":"Hello Mr. Vetter,<br> Sorry for the late reply, but I was hoping to have solved the problem over the weekend, unfortunately that&#39;s not the case. So, on the Neo, except for the predefined inputs for the tail and channels 1-3 for the swashplate, the ESC (Castle HV 80 without BEC) is connected to the ESC. The external receiver voltage is connected to AUX 3. AUX 2 and channel 4 are free. The banks in the transmitter are assigned to AUX 2 and channel 7 respectively, and are also visible in the stabilization software, just as the upshifting is visible in the software on channel 1 (motor). I&#39;ve programmed three linear throttle curves in the transmitter at 65%, 70%, and 75%. Interestingly, I don&#39;t have any problems with another helicopter that has a mini stabilizer and a 6-channel receiver installed. I hope this information is helpful. I flew the Microbeast until the end of last year and am a VBar newbie, but I&#39;m now getting along great with setting it up via the software and my two Logos, a 500se and a 600se\/700, fly great ???? except for the problem with the switching on the 700.<br> greeting<br> Conny Hoff","note":"machine-translated from German"}