{"ok":true,"content":"I don&#39;t have a current DX6 right now - but...<br><br> If you set the TS in the TX to H1, the individual control functions should already be available. Then you just need to assign them, and adjust the paths and directions in the transmitter according to our requirements.<br><br> The same applies to one channel for the motor switch (which must show at least on and off in our case; AR would then be the center of the channel if desired) and one for the 3 banks (rotational speeds are then stored in the stabilizer).<br><br> <a href=\"https:\/\/www.vstabi.info\/de\/neo_transmitter\" target=\"_blank\" rel=\"noopener noreferrer\">https:\/\/www.vstabi.info\/de\/neo_transmitter<\/a><br><br> I once had an old DX 6i for V5 - maybe this will help:<br><br> <a href=\"https:\/\/www.vstabi.info\/de\/node\/68\" target=\"_blank\" rel=\"noopener noreferrer\">https:\/\/www.vstabi.info\/de\/node\/68<\/a><br>\n<br>\nregards (EN) \/ Gruss (DE) \r<br>\n\r<br>\nRainer Vetter\r<br>\n\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\nPosting and answering - please use a PC and a standard keyboard. Answer all questions fully, take the needed time, don't forget probably requested attachments.\r<br>\n\r<br>\nF\u00fcr Posts und Antworten bitte einen PC und eine richtige Taststaur benutzen sowie alle Fragen vollst\u00e4ndig abarbeiten. Nehmt Euch Zeit, beantwortet R\u00fcckfragen in Ruhe und vollst\u00e4ndig.\r<br>\n_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ \r<br>\n<i>F\u00fcr Einzelkommunikation bitte <strong>ausschlie\u00dflich Email<\/strong> verwenden! - PN, Messenger, Chat usw. werden nicht bearbeitet.\r<br>\nFor single user communication please send a <strong>email only<\/strong>! PM, Messenger, Chat etc. won't be read.<\/i>","note":"machine-translated from German"}