{"ok":true,"content":"Good morning,<br><br> I recently bought a T-Rex 470LP combo, which also included the vStabi Neo Express.<br> I also have a Spektrum DX6 transmitter and an AR610 receiver. Unfortunately, I can&#39;t connect the latter to the neo because the housing doesn&#39;t accept the connector.<br> I then unscrewed the receiver&#39;s casing and connected the connector (Bind\/Data Port). The vStabi recognized a receiver\u2014I think. The 610 was already bound to the DX6, but no control inputs were being accepted. I connected the receiver to the vStabi&#39;s AUX1 port using the included cable. (Unfortunately, I haven&#39;t found any specific information yet on how else I should have connected it.) But as I said, the result was negative. Control wasn&#39;t possible. But that probably wouldn&#39;t have been advisable anyway, if I understood the videos correctly, since a 22ms connection is established there. With satellites, it would only be 11ms if they are connected directly to the vStabi Neo, right?<br><br> I&#39;ve ordered the SPM9645 satellite receiver. Before unpacking it, I&#39;d like to ask how to get this setup working. Is it enough to simply connect the satellite to the vStabi Neo? How do I then put the receiver into bind mode? (I know how to connect the DX6 to receivers that are already in bind mode.)<br><br> Buying a VBar transmitter isn&#39;t an option for me right now. Firstly, because there don&#39;t seem to be any available at the moment, and secondly, because they cost more than twice as much as the helicopter. Therefore, I&#39;d like to continue using my existing system.<br><br> I would be very grateful for your help.<br><br> Until then<br><br> Termin","note":"machine-translated from German"}