{"ok":true,"content":"Hi Eddi,<br><br> Could you perhaps tell me something more about the question quoted below? I&#39;d just like to understand if simply finding zeros in the function is enough...<br> Could it perhaps only be due to the Z-axis sensor, and this error only becomes visible when the lightness setting is activated?<br> Is the Z-axis sensor only used in this case?<br><br> Since I set the function to 0, there have been no more errors, and I couldn&#39;t restore them even with the same boundary conditions.<br><br> Thank you and best regards!<br><br> andrea.parigi wrote:<br> -------------------------------------------------------<br> My previous question was how to use this parameter<br> &gt; should have been avoided was perhaps not entirely correct<br> &gt; formulated:<br> &gt; Assuming it could be done with the use of the<br> &gt; Ease of use is an initialization problem of the<br> &gt; Sensors are triggered because they are in the<br> The case will be reviewed to determine the cause.<br> &gt; difference to a VBar where this function<br> &gt; is competent?<br> Are there hardware differences between older and<br> &gt; New Vstabis? Backwards compatibility? Or,<br> &gt; only local, a latent sensor error on my<br> &gt; Stabilization made visible by this function<br> &gt; was?<br> &gt;<br> Thanks and best regards!<br> &gt; :-)","note":"machine-translated from German"}