{"ok":true,"content":"Good morning Eddi,<br><br> Thanks for your comments, I will check the BEC voltage again this evening with my oscilloscope.<br> However, I can well imagine that the problem does not lie there, because up to now the installed components have always gone into operation without any problems (it&#39;s not a new helicopter - built in 2015).<br><br> BEC is a PowerBox Source with 2x 2S 2400mAh batteries, regulated voltage set to 7.4V.<br> Today I will measure the &quot;start-up time&quot; of the voltage; in any case, it would be strange if the VBar had a problem with it after so many cycles.<br><br> I can live well without the ease of flying; it was not my intention to activate that.<br> I only performed the firmware update because I wanted to try the Wag-Sup.<br> Since the firmware update, this was the first time I&#39;d flown the model, meaning the errors only started occurring after the update. Of course, this doesn&#39;t rule out a sensor malfunction; the timing would be pure coincidence.<br><br> In any case, I will try to control the voltage in order to be able to give a concrete answer about it.<br><br> My earlier question about how to handle this parameter may not have been phrased quite correctly:<br> Assuming that the use of lightness could cause an initialization problem of the sensors because they are checked in that case, what is the difference to a VBar where this function works well?<br> Are there any hardware differences between older and newer VBars? What about backward compatibility? Or, is it just a local issue, a latent sensor error in my stabilizer that was made visible by this function?<br><br> Thanks and best regards!<br> :-)","note":"machine-translated from German"}