{"ok":true,"content":"Hi Andrea,<br><br> Well, the issue of the power supply isn&#39;t off the table for me yet: electronic devices also need to start up and ramp up.<br> With red controllers, there was a time when this was virtually reproducible, although not with all types.<br> However, if you had such a candidate, you could observe it with the controller 5, 6, 7\/10 times; if you used a suitable charged battery, and only plugged in the flight battery after initializing the electronics, it was 10\/10 times good.<br> During initialization, the NEO needs a stable, reliable voltage of 4+ V almost immediately in order to function properly; otherwise, the sensors will not settle correctly or may subsequently change their midpoints, resulting in a -bup- error message.<br> A battery provides this immediately; with regulators\/BECs, you can sometimes see on an oscilloscope how the voltage increases when the device boots up.<br><br> That&#39;s why I pay close attention.<br><br> Normally, the ease setting should be set to 0 by default; with new stabilizers, it would need to be activated manually.<br> Then the acceleration sensors are also queried and initialized when the device is switched on; otherwise, they are not.<br> However, in some stabilizers, the register (drawer, memory location for the parameter) does not seem to contain -1 (never set, never used, default value) or 0 (manually set to off), but rather, for example, 35.<br> It _could_ be that a setup was previously loaded onto the stabilizer, containing data, or possibly also if the stabilizer had already been used for something else.<br><br> The problem is not lightness, but &#39;something&#39; with the accelerometers, either an initialization problem (voltage, movement, Z-axis stuck due to vibration) or actually a sensor malfunction.<br><br> If you can live with zero ease, all good, the gyros for flight attitude stabilization are, to the best of our knowledge, unaffected by this.<br> Alternatively, you can send the stabilizer in, and we will check it for any possible malfunction.<br> If you were to load a Rescue package, you could potentially use a VBar Control in Rescue mode to see where the sensors are positioned or whether they are drifting (whether the center is moving).\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}