{"ok":true,"content":"Hi Eddi,<br><br> Thanks for the reply! Regarding your questions:<br><br> The Neo is installed in a scale helicopter. I can pretty much rule out vibrations since there aren&#39;t any, according to the log, and I always pay particular attention to this. This model has been running with this Neo for several years now.<br><br> Correct, Neo has the Pro version installed and is on the latest firmware, I will check this parameter!<br><br> Your suggestion about the power supply caught my attention, as I found a faulty voltage regulator (from 7.4V to 6V for a non-HV servo on the load hook) while investigating at home yesterday, and it was drawing a lot of current. That could be a clue. The BEC is the power box, but it shouldn&#39;t fail because of something like that. We&#39;ll see.<br><br> As you said, after the message it was working again, so that shouldn&#39;t necessarily indicate a defective sensor.<br><br> I&#39;ll do some more research this evening and give you an update, see you then!<br><br> Thanks and regards<br> Andrea","note":"machine-translated from German"}