{"ok":true,"content":"Hello everyone!<br><br> I had an error with my VBar Neo Pro today, namely &quot;IMU Sensor Error&quot;:<br> The first flight went well, but after a short break and battery change, the Vstabi Neo could not initialize when switched on; after about 10 seconds, the red flashing V appeared and the swashplate jerked up\/down.<br> After about 30 seconds, the swashplate stopped twitching, but the V continued to flash red.<br> Oddly enough, after the swashplate stopped flashing, the event log showed the message &quot;Everything is OK&quot;.<br><br> After several attempts to start it, I accidentally plugged in the USB cable (which is permanently attached to the Vstabi, as it is difficult to access in the model) and the Vstabi initialized immediately and correctly.<br><br> Despite several attempts to reproduce the error, with and without a USB cable, it was no longer possible to reproduce it.<br><br> Do you have any ideas what it could be?<br> The log file is attached.<br><br> Thank you and best regards!<br> Andrea&#39;s file attachments:<br> <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?53,file=26531,filename=log-20011127-03-04-2022-18-00-16.zip\" target=\"_blank\" rel=\"noopener noreferrer\">Open<\/a> | <a href=\"https:\/\/www.vstabi.info\/forum\/file.php?53,file=26531,filename=log-20011127-03-04-2022-18-00-16.zip,download=1\" target=\"_blank\" rel=\"noopener noreferrer\">Download<\/a> - log-20011127-03-04-2022-18-00-16.zip (653 bytes)<br>\n                    \n                ","note":"machine-translated from German"}