{"ok":true,"content":"Good morning,<br><br> The optimizer handles the stopping behavior, depending on the direction of rotation of the rotor or the torque, in order to (within the limits of possibility, rotational speed, tail rotor power) stop the aircraft where it is steered, not to overshoot and then turn back, for example, or to stop softly, or to stop very differently.<br><br> Now, 1+1 = at a different RPM I need different values. That means in your example, at 1000 RPM the optimizer would probably calculate a very high &#39;value&#39;, while at 1800 RPM that would be too much. I know, for men there&#39;s no such thing as too much; if it bangs loudly, it&#39;s just good enough, but it could always bang louder... but that a) also puts strain on the mechanics and b) doesn&#39;t achieve anything more.<br><br> However, you can&#39;t generalize; helicopter size, mass, rotational speed, blades, tail rotor blades, tail rotor gear ratio, tail angle, etc., are all factors that the control loop can or must work with, and that&#39;s a whole lot of variables, and the optimizer can&#39;t perform magic, can&#39;t outsmart physics.<br><br> Therefore<br><br> Quote: <strong>RV<\/strong><br> Just try it out, nothing will break.<br><br> :-) \r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}