{"ok":true,"content":"Hi,<br><br> This will not be due to the servo, but rather to the transmitter or the fail-safe center position in the receiver (which one?).<br><br> When switched on, the VBar learns the center point provided by the controller.<br> If, for example, you switch on a different flight phase, even a mini-trim that is accidentally engaged can cause the VBar to &#39;think&#39; that it is being controlled.<br><br> This can also happen if the stick&#39;s center position still wanders after switching on (potassium drift).<br><br> The same applies to fail-safe if the stored center position from the receiver (which is normally output even if the transmitter and receiver have not yet connected) differs from the one in the transmitter (even a changed stick calibration can cause this).<br><br> If it works fine with another model, it&#39;s more likely related to the model memory or the receiver&#39;s center position than to the potentiometer, for example, as this would otherwise be the case with all models (more or less... there&#39;s also a mini dead zone, which can be set in the setup\/transmitter for third-party transmitters \u2013 you could try setting it to 10-15 or higher for testing purposes to see if the problem persists).<br> You could also try changing the stick mode so that the roll potentiometer goes to the tail channel \u2013 but of course you can&#39;t fly like that.<br> And reprogram the fail-safe, and make sure that no trims are stored in the flight phases, or turn off the trim if it isn&#39;t already off.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}