{"ok":true,"content":"Hi Robert,<br><br> I saw this by chance years ago when I had servos on the table for testing (current\/back voltages).<br><br> Advantage: the current draw during startup was significantly lower\/less critical, which can be particularly helpful with BECs that need some time to reach full voltage and performance. In contrast, with \u2013 bam \u2013 16 amps, the BEC might immediately shut down, initialization takes forever, or fails altogether.<br><br> The issue is not necessarily &#39;related to FBL systems&#39;, but rather the sometimes brutally high current draw when the servos jump into the alert position (swashplate position), possibly with comparatively heavy blades that are not optimally aligned, and with a hanging swashplate.<br><br> A possible disadvantage: if a loose connection causes one or more servos to delay, even stranger things could happen.<br> It&#39;s also possible that there&#39;s some kind of warm start, where the servo only starts up slowly again after a few seconds without power, but I don&#39;t know.\r<br>\n\r<br>\nGr\u00fc\u00dfle\r<br>\n\r<br>\nEddi<br>\n<br>\nBorn to fly ...\r<br>\nforced to work.","note":"machine-translated from German"}