{"ok":true,"content":"Hi,<br><br> Other things you _could_ try:<br><br> You can adjust the motor off point (-100) in controller II.<br> You _could_ try activating the throttle servo settings (attention: now the controller is connected to the pitch\/throttle stick _with_ the stored pitch curve), and (stick to full negative, off) increase the value until the controller starts, then lower it again by e.g. 5 points (safety).<br><br> Try again.<br><br> When the controller is switched on, the VBar makes a jump from 0 (throttle) to 10%, then the throttle value increases along a ramp.<br> The controller performs its soft start during this time until it hands over to the RC signal.<br> If the endpoints don&#39;t harmonize, it may take some time until the controller sees enough throttle to respond.<br><br> But even if everything else works, one can live with the four seconds of hesitation...<br><br> Castle is simply a part of RC history by now, but that doesn&#39;t mean you can&#39;t still use the controllers :-)<br><br> \u2014Eddi<br><br> Born to fly ...<br> forced to work.","note":"machine-translated from German"}